On the line, uneven Preform heating doesn’t hide. You see it immediately—thin walls, stress marks, bottles that just miss spec. You chase temperature balance through the heating tunnel, and still end up with rejects. We build infrared heating systems that go after the actual root cause: energy delivery that isn’t consistent across the preform body. What matters, technically We match the OEM heating zones with short-wave quartz emitters and R7s connectors, sized for your blow molder—Sidel, Krones, SIPA, Husky, SACMI, or Nissei ASB. Output is tuned to PET absorption, so the surface heats fast while the core stays even. Zone power is adjustable section by section, letting you hold shoulder, neck, and body temperature within tight bands. Reflectors are shaped to cut cross-belt shadowing and keep the pattern repeatable. Why this works in practice With uniform heating, you can shorten the heating cycle and still hit stretch ratios without stress. The payoff is more bottles per hour, fewer rejects, and less scrap. Energy use drops because emitter power is matched to the preform, not cranked up to compensate for hot/cold spots. We also see longer emitter life—units running 5,000+ hours with under 5% output loss—so maintenance windows come around less often. What you need to know up front Installation is straightforward on most machines, but oven length and belt geometry matter. Measure the tunnel, confirm the connector type and voltage, and map the zones to your PLC. Some older lines need minor guarding changes to clear the emitter length. Spec the system to your exact machine model and preform geometry, or you’ll lose the gains fast.