The ERP-Compliant Halogen Heater: Built for the Factory Floor
We built this heater for the kind of work that happens on a factory floor. Where you need serious heat, packed into a small space, and a unit that just drops right in. It’s a 400V, 2500W halogen tube, about 300mm long, and it comes with an R7s connector. This setup is all about delivering a blast of focused heat, fast, without tripping your system.
The Power Behind the Heat
Let’s talk about what this thing actually does. Running at 400V and 2500W, it packs a huge punch in a small package. The 300mm length concentrates all that heat into one spot, which is perfect for jobs that need localized heating. And it’s fast. Seriously fast. This isn’t a slow, gentle warm-up. You feel the heat almost immediately, so your controls need to be ready for that quick burst. Running on 400V also keeps the current lower than some other options. That means you can use smaller wiring and put less strain on your contactors. It’s a practical advantage that saves you time and hassle on the install.
A Closer Look at the Build
The heart of this heater is the halogen element, sealed tight inside a quartz tube. A reflector coating is there to push all that infrared energy forward, where you need it. Less wasted heat means more efficient work. This coating also helps keep the quartz clean, so the heat output stays steady over time. Then there’s the R7s connector. It’s a simple, two-pin setup that makes this thing a true plug-and-play replacement. When a tube needs swapping, you can get it done in minutes. Just pop the old one out, put the new one in, and you’re back up and running. No mess, no downtime.
Where It Shines
This heater is your go-to when you’re short on space but need intense, fast heat. Think of it for jobs like heating PET preforms, forming plastic, or sealing packaging. The combination of 400V, 2500W, and the R7s design gives you a massive amount of power in a tiny footprint. But here’s the thing to keep in mind: this is a powerful, focused heat. The components around it and your machine’s cooling system need to be built to handle that kind of intensity. It’s a lot of power, and you’ve got to make sure the rest of your setup is ready for it.